Turn Signal Light - Honda VT750C2 Shadow Spirit Service Manual

LIGHTS/METERS/SWITCHES
Remove the nuts, bolts and headlight case from the
HEADLIGHT CASE
brackets.
Route the wire
Install the headlight case in the reverse order of
harnesses properly
removal.
(page 1-22J.
Adjust the headlight aim (page 4-22).
TURN SIGNAL LIGHT
BULB REPLACEMENT
/
BOLTS
Remove the screw and turn signal light lens.
While pushing the bulb in, turn it counterclockwise
to remove it, and replace it with a new one.
Make sure the lens gasket is installed in position
and is in good condition, and replace it with a new
one if necessary.
Install the lens, aligning its slot with the tab of the
turn signal light, and tighten the screw.
SCREW GASKET LENS
REMOVAUINSTALLATION
FRONT
Remove the headlight unit (page 21-5).
Disconnect the turn signal 3P connectors.
• Light blue: Right turn signal connector
• Orange: Left turn signal connector
HEADLIGHT CASE
3P CONNECTORS
Remove the bolt, collar and turn signal light.
TURN SIGNAL LIGHT
Route the turn
Installation is in the reverse order of removal.
signal wire properly
(page 1-22J.
'"
21-6