Honda VT750C2 Shadow Spirit Service Manual page 117

FUEL SYSTEM
Install the diaphragm/vacuum piston into the carbu ­
COMPRESSION SPRING
retor body being careful not to damage the jet nee­
dle.
Lift the bottom of the piston with your finger to set
the diaphragm rib into the groove in the carburetor
body.
Be
careful not to
Install the compression spring and vacuum cham­
pinch the
ber cover while lifting the piston in place. Align the
diaphragm.
bosses of the cover with the grooves of the carbure­
tor body and secure the cover with at least two
screws before releasing the vacuum piston.
Install and tighten the vacuum chamber cover
screws to the specified torque.
TORQUE: 2.1 N·m (0.2 kgf·m, 1.5 Ibf·ft)
CARBURETOR HEATER
Coat new O-rings with engine oil and install them
onto the carburetor heater.
Install the carburetor heater into the carburetor
body.
Install the set plate onto the carburetor heater.
Install and tighten the carburetor heater set plate
screws to the specified torque.
TORQUE: 3.4 N' 11l (0.3 kgf·m, 2.5 Ibf·ft)
RIB
.~
DIAPHRAGMNACUUM PISTON