Brake Pad/Disc; Brake Pad Replacement - Honda VT750C2 Shadow Spirit Service Manual

HYDRAULIC BRAKE
Install the following:
SCREWS
- Diaphragm
- Set plate
- Reservoir cap
- Screws
Tighten the screws to the specified torque.
TORQUE: 1.5 N·m (0.2 kgf·m, 1.1 Ibf·ft)
BRAKE PAD/DISC
BRAKE PAD REPLACEMENT
Check the brake
Push the caliper piston all the way in to allow instal ­
fluid level in the
fation of new brake pads.
reservoir as this
operation causes
the level to rise.
Remove the pad pin plug and loosen the pad pin.
Pull the pad pin out of the caliper body while push­
ing in the pads against the pad spring.
Remove the brake pads.
Make sure the pad
Install new brake pads into the caliper so their ends
spring
is
installed
rest into the pad retainer on the bracket properly.
correctly. Always
replace the brake
pads in pairs to
ensure even disc
pressure.
17-7