Honda VT750C2 Shadow Spirit Service Manual page 56

FRAME/BODY PANELS/EXHAUST SYSTEM
Remove the following:
GRAB RAILS
- Bolts
- Washers
- Grab rails
- Rear fender assembly
NOTE:
When removing the rear fender assembly, be care­
ful not to damage the wires.
INSTALLATION
Route the wires
Installation is in the reverse order of removal.
properly
(page 1-22).
TORQUE:
Grab rail mounting bolt:
64 N·m (6.5 kgf·m, 47 Ibf.ft)
REAR FENDER
ASSEMBLY
REAR FRAME/REAR FENDER A
REMOVAL
Remove the rear fender assembly (page 3-6).
Release the rear frame bosses from the rear fender
holes, then remove the rear frame/rear fender A.
NOTE:
When removing the rear frame/rear fender A, be
careful not to damage the wires.
Remove the rubber from the rear fender A.
Remove the grommet from the rear fender.
HOLES
~BER
-----------~--
. _ ­
3-7