Speedometer/Vs Sensor; Power/Ground Line Inspection; Speedometer Inspection - Honda VT750C2 Shadow Spirit Service Manual

2007-2009 motorcycle
Hide thumbs Also See for VT750C2 Shadow Spirit:
Table of Contents

Advertisement

LIGHTS/METERS/SWITCHES
SPEEDOMETER/VS SENSOR
POWER/GROUND LINE INSPECTION
Remove the speedometer assembly (page 21-10).
POWER INPUT LINE
Measure the voltage between the Brown wire termi­
SPEEDOMETER CONNECTORS
nal
(+)
of the speedometer 12P connector and
ground (-).
(viewed from the wire harness side)
There should be battery voltage with the ignition
switch turned to ON.
If there is no voltage, check the following:
-
Open circuit in the Brown wire
-
Blown sub fuse 10A(METER, TAIL)
GROUND LINE
Check for continuity between the Green/black wire
terminal and ground.
There should be continuity at all times.
If there is no continuity, check for an open circuit in
the Green/black wire.
BACK-UP VOLTAGE LINE
Check this line if the odometer/trip meter does not
function.
Measure the voltage between the Pink wire terminal
(+)
and ground (-).
There should be battery voltage at all times.
If there is no voltage, check the following:
-
Open circuit in the Pink wire
-
Blown sub fuse 10A (ODOMETER)
-
Open circuit in the Red wire
BROWN
SPEEDOMETER CONNECTORS
(viewed from the wire harness side)
SPEEDOMETER INSPECTION
Speed()meter does not operate
el1eCk that the indicators function properly.
If they do not function, check the power/ground line
Cpage 21-9).
Remove the speedometer assembly (page 21-10).
Support the motorcycle securely and raise the rear
wheel off the ground.
Shift the transmission into neutral and turn the igni­
tion switch to ON.
Measure the voltage between the Black/yellow
(+)
and Green/black (-) wire terminals of the speedome ­
ter connector.
Slowly turn the rear wheel by hand.
There should be 0 V to 5 V pulse voltage.
• If pulse voltage appears, replace the speedome ­
ter.
• If pulse voltage does not appear, check the fol ­
lowing:
- Black/yellow wire for an open or short circuit.
- Green/black wire for an open circuit.
If the wires are OK, check the VS sensor
(page 21-11).
SPEEDOMETER CONNECTORS
(viewed from the wire harness side)
BLACKIYELLOW
GREEN/BLACK
21-9

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents