Honda VT750C2 Shadow Spirit Service Manual page 289

CRANKSHAFTITRANSMISSION
Refer to torque
wrench reading
information, on
page 13-3 'Service
information'.
Refer
to
torque
wrench reading
information, on
page 13-3 'Service
information'.
Apply engine oil to the threads and seating surface
of a new bearing outer race lock nut and tighten itto
the specified torque using a special tool.
TOOL:
Lock nut wrench, 36 x 47.8 mm 07916-MB00002
TORQUE:
Actual: 98 N·m (10.0 kgf·m, 72Ibf.ft)
Indicated:89 N·m (9.1 kgf·m, 66Ibf.ft)
Apply engine oil to the threads and seating surface
of a new inner race lock nut.
Hold the driven gear shaft and tighten it to the spec ­
ified torque using the special tools.
TOOLS:'
Shaft holder A 07PAB-0010100 or
07923-6890101
(U.S.A. only)
Lock nut wrench, 36 x 47.8 mm 07916-MB00002
Differential inspection tool 07KMK-HC50101 or
07KMK-HC5010A
(U.S.A. only)
TORQUE:
Actual: 73 N·m (7.4 kgf·m, 54 Ibf·ft)
Indicated:66 N·m (6.7 kgf·m, 49lbf·ft)
Stake the bearing inner and outer race lock nuts.
Pack grease into the seal lip cavity of a new oil seal
and installitimtil the ring groove is visible so the
stopper ring can be installed.
Install the stopper ring into the bearing holder
groove securely.
NOTE:
• Install the stopper ring with the chamfered edge
facing the thrust load side.
• Do not reuse worn stopper ring which could eas­
ily spin in the groove.
• Check that the stopper ring is seated in the
groove.
INSPECTION TOOL
SHAFT HOLDER
.. . ,,/It
II
lIliijjll
INNER LOCK NUT
13-42