License Light - Honda VT750C2 Shadow Spirit Service Manual

I.IGHTS/METERS/SWITCHES
REMOVAL/INSTALLATION
Remove the rear framelrear fender A (page 3-7).
Release the brake/tailllicense light wire from the
clamps of the rear frame.
Disconnect the license light 2P connector and
remove it from the rear fender A.
Remove the nuts, collars and brake/taillight.
Route the wires Installation is in the reverse order of removal.
properly
TORQUE:
(page 1-22).
Brake/taillight mounting nut:
6.3 N·m 10.6 kgf·m, 4.6 Ibf·ft)
COLLAR
BRAKEfTAIL LIGHT
LICENSE LIGHT
BULB REPLACEMENT
Remove the screws and license light cover.
LICENSE LIGHT COVER
Remove the bulb and replace it.
Make sure that the lens gasket is installed in posi ­
tion and is in good condition, and replace it with a
new one if necessary.
Install the removed parts in the reverse order of
removal.
GASKET SCREWS
REMOVAL/INSTALLATION
Remove the rear frame/rear fender A (page 3-7).
Disconnect the license light 2P connector.
Remove the nuts, collars, clamp and license light.
Route the wires Installation is in the reverse order of removal.
properly
.
(page 1-22).
2P CONNECTOR
BULB
CLAMP
LICENSE LIGHT
21-8