Crankshaft/Connecting Rod; Crankpin Bearing - Honda VT750C2 Shadow Spirit Service Manual

CRANKSHAFTITRANSMISSION
Loosen and remove the 6 mm and 8 mm bolts with
washer in a crisscross pattern in several steps.
Turn the shift drum until the position as shown.
Place the crankcase with the left crankcase down
and remove the right crankcase.
NOTE:
• Separate the right crankcase from the left crank ­
case while prying at the points as shown.
• Separate the right crankcase from the left crank ­
case while tapping them at several locations with
a soft hammer.
Remove the dowel pins and pipe seal.
Clean off the sealant from the left and right crank­
case mating surfaces.
PIPE SEAL
CRANKSHAFT/CONNECTING ROD
CRANKSHAFT REMOVAL
Separate the crankcase (page 13-9).
During crankshaft
Remove the crankshaft/connecting rod from the left
and connecting rod
crankcase.
service, be careful
not to damage the
main journal or
crankpin bearing
inserts.
13-10