- - - - -
- - - - - -
- - - - -
CRANKSHAFTITRANSMISSION
(U.S.A. only)
Place the threaded adaptor in the end of the output
drive gear shaft and tighten the adaptor.
Place the compressor seat over the threaded adap
tor with the stepped side facing upward.
Install the assembly bolt through the assembly col
lar and attach it to the threaded adaptor.
Center the compressor seat with the damper cam
then begin to tighten the 23 mm nut of the assembly
bolt until the snap ring is visible so it can be
remoVed.
TOQLS;· .
AsserntilYcbolt
07965-1660200
Assembly collar
07965-166030A or
07965-1660302
Compressor seat
07967-9690200
Threaded adaptor
07965-KA30000
Snap ring pliers
07914-5670101 not
available in U.S.A.
or
07914-5670100
Remove the snap ring, special tools, damper cam
and spring from the drive gear shaft.
Remove the bolt and stay.
Remove the output gear case mounting bolts.
Removethe output gear case assembly and O-ring.
ASSEMBLY BOLT
ASSEMBLY COLLAR
It:::::
THREADED ADAPTOR
COMPRESSOR SEAT
SNAP RING
DAMPER CAM
OUTPUT DRIVE GEAR SHAFT
-
13-aO