Ignition Switch - Honda VT750C2 Shadow Spirit Service Manual

LIGHTS/METERS/SWITCHES
IGNITION SWITCH
INSPEC1"ION
Remove the seat (page 3-3).
Disconnect the ignition switch 2P (Black) and 1P
(Natural) connectors.
Check for continuity between the switch side con ­
nector terminals in each switch position.
Continuity should exist between the color coded
wires as shown in the chart.
BulO
RlBI R
REMOVAUINSTALLATION
Remove the follOWing:
- Seat (page 3-3)
- Left side cover (page 3-3)
Disconnect the ignition switch 2P (Black) and 1P
(Natural) connectors.
Release the wire from the wire band.
Remove the screw and Ignition switch cover.
Remove the bolts and ignition switch assembly.
Remove the bolts, ignition switch, collar and switch
base from the stay.
Install the switch base, ignition switch and collar to
the stay.
Tighten new bolts to the specified torque.
TORQUE: 12 N·m (1.2 kgf·m, 9 Ibf.ft)
Install the ignition switch assembly to the frame.
Install the ignition switch cover and tighten the
screw.
TORQUE: 1 N·m (0.1 kgf·m, 0.7 Ibf·ft)
Route the ignition switch wire properly (page 1-22).
Connect the ignition switch 2P (Black) and 1P (Natu ­
ral) connectors.
Install the following:
- Left side cover (page 3-3)
- Seat (page 3-3)
BOLTS BOLTS
IGNITION SWITCH/COLLAR/SWITCH BASE
The ignition switch
mounting bolt
heads are broken
by tighten them to
the specified
torque.
21-16