ALTERNATOR/STARTER CLUTCH
STATOR REMOVAL
Remove the following:
- Seat (page 3-3)
-
Left side cover (page 3-3)
-
Left crankcase rear cover (page 3-5)
Disconnect the alternator 3P (Natural) connector.
Release the wires from the clamps and wire bands.
Place a container under the left crankcase cover to
catch the engine oil.
Loosen the bolts in
Remove the bolts. clamps and left crankcase cover.
a
crisscross pattern
NOTE:
in several steps.
• The left crankcase cover (stator) is magnetically
attached to the flywheel, be careful during
removal.
• Be careful not to damage the alternator cover.
Be
careful not
to Remove the dowel pins and clean off the sealant
damage the mating
from the mating surface.
surface.
124