FINAL DRIVE
Coat a new O-ring with grease and install it into the
PINION RETAINER
retainer groove.
~"
The lock tab is
available in the two
types (A and
B)
as
shown.
111 .......
O-RING
Hold the gear case in a vise with soft jaws.
RETAINER WRENCH
Install the pinion retainer into the gear case and
tighten it to the specified torque using a special tool.
TOOL:
Retainer wrench
07910-MA10100
TORQUE: 108 N'm (11.0 kgf·m, 80 IbUt)
Install the lock tab with its tab facing up, depending
on the position of the pinion retainer grooves in
relation to the lock tab and tighten the bolt.
TORQUE: 10 N·m (1.0 kgf'm, 7Ibf·ft)
Clean the threads of the pinion gear shaft and pin
ion joint nut thoroughly.
Apply locking agent to the joint nut threads and
install the pinion joint and joint nut onto the pinion
gear shaft.
JOINT NUT
ew
14-18