HYDRAULIC BRAKE
Remove the caliper pin boot and pad retainer from
PAD RETAINER
BOOT
the bracket.
Clean the retainer and bracket mating surfaces.
BRACKET
Do not use high
Place a shop towel over the pistons.
pressure air or bring
Position the caliper body with the piston facing
the nozzle too close
down and apply small squirts of air pressure to the
the inlet.
fluid inlet to remove the pistons.
Be careful not to
Push the dust and piston seals in and lift them out.
damage the piston
Clean the seal grooves, caliper cylinders and pis
sliding surface.
tons with clean brake fluid.
~
/
INSPECl"ION
Check the caliper cylinders for scoring, scratches or
damage.
Measure the caliper cylinder I.D.
SERVICE LIMIT: 27.060
mm
(1.0654 in)
17-14