Honda VT750C2 Shadow Spirit Service Manual page 381

REAR WHEEL/BRAKE/SUSPENSION
Install the following:
STOPPER ARM NUTIWASHERS/BOLT
Carefully align the
swingarm pivots
with the pivot bolts.
- Stopper arm
- Bolt
- Spring washer
- Washer
- Nut
Tighten the nut and install a new cotter pin.
Apply 1 g of molybdenum disulfide grease to the
output shaft splines.
Install the universal joint onto the output shaft.
Set the swingarm into the frame and hold it.
Install the joint bo.otovert!le output gear case.
-
,-
, - -
--
Insta~ILthe !ett..al1dr;igh!'Il!M-ofbolts.
, -
~ -C-,
'-'0:--'_--'.-'-:'-:­
Tighten the left piv,Pt bolt tdthe specified torque.
TORQUE: 103 N:rri ,(10.5 kgf·m, 76 Ibf·ft)
Temporarily tighten the right pivot bolt to the speci­
fied torque. '
M6vethesWiQ~8'rin up and down several times to
seat lhe Rivoib'e~rings.
Loosen the right pivot bolt counterclockwise 1/4
tUrn{90o)
li!n(JJigh~en it to the specified torque.
TORQUE: 22
N;gHZ:Zkgf·m,
16 Ibf·ft)
16-26