Honda VT750C2 Shadow Spirit Service Manual page 188

.....
<,.4''''''''
CYLINDER HEAD/VALVE
Install the cylinder head to the cylinder.
Apply engine oil to the cylinder head each bolts and
nuts threads and seating surfaces.
Install and tighten the cylinder head 8 mm bolts, 10
mm nuts and washer to the specified torque.
TORQUE:
10 mm nut: 47 N·m (4.8 kgf·m, 35Ibf·ft)
8 mm bolt: 23 N·m (2.3 kgf·m, 17 IbHt)
Install and tighten the 6 mm bolt securely.
NOTE:
• Tighten all to hand-tight, then torque the larger
fasteners before tightening the smaller fasteners.
• Tighten the bolts and nuts in a crisscross pattern
in several steps.
Install the cam chain tensioner, aligning its end with
the groove in the crankcase.
Tighten the tensioner bolts as follow:
BOLTS/SEALING WASHER
1. Temporarily install the tensioner bolts with new
sealing.washers.
fI,
~..
2. Tighten the cylinder head side cam chain
tensioner bolt to the specified torque.
TORQUE: 10 N·m
(1.0
kgf·m, 7Ibf·ft)
3. Tighten the cylinder side cam chain tensioner
bolt to the specified torque.
TORQUE: 10 N·m (1.0 kgf·m, 7 Ibf·ft)
Install a new a-ring to the water hose joint.
9-25