Honda VT750C2 Shadow Spirit Service Manual page 95

LUBRICATIQN SYSTEM
Check the piston for wear, sticking or damage.
Check the valve spring for wear or fatigue.
Check the relief valve body for clogging or damage.
Clean all parts and assemble the relief valve in the
reverse order of disassembly.
NOTE:
• Install the snap ring with the chamfered edge
facing the thrust load side.
• Do not reuse worn snap ring which could easily
spin in the groove.
• Check that the snap ring is seated in the groove.
INSPECTION
NOTE:
Measure each clearance at several points and use
the
larg~st
reading to compare the service limit.
BODY CLEARANCE
Temporarily assemble the inner rotor, outer rotor,
drive pin and pump shaft into the pump body.
Measure the body clearance.
SERVICE I.IMIT: 0.35 mm (0.014 in)
TIP CLEARANCE
Measure the tip clearance.
SERVICE I.IMIT: 0.20 mm (0.008 in)
PISTON RELIEF VALVE BODY
~.
SPRING
?,
~
SNAP RING WASHER
BODY CLERARANCE:
TIP CLEARANCE:
5-8.