Horn; Turn Signal Relay - Honda VT750C2 Shadow Spirit Service Manual

LIGHTS/METERS/SWITCHES
Install a new sidestand switch bolt.
Tighten the bolt to the specified torque.
TORQUE: 10 N·m (1.0 kgf·m, 7 Ibf·ft)
Route the
Install the removed parts in the reverse order of
sidestand switch
removal.
wire properlv
(page 1-22).
HORN
INSPECTION
Disconnect the connectors from the horn.
Connect a 12 V battery to the horn terminals.
The horn is normal if it sounds when the 12 V bat­
tery is connected across the horn terminals.
REMOVAL/INSTALLATION
Disconnect the connectors from the horn.
Remove the bolt and horn.
Install the horn to the frame, aligning its flat with the
horn stay.
Install and tighten the bolt to the specified torque.
TORQUE: 21 N·m (2.1 kgf·m, 15Ibf·ft)
Connect the connectors.
... ...._
TURN SIGNAL RELAV
Turn signal light does not blink
Remove the right side cover (page 3-3).
Remove the turn signal relay from the stay.
Slide the rubber cap and disconnect the connector.
Connect the White/green and Gray wire terminals of
the wire harness side connector with a jumper wire.
Turn the ignition switch to ON and check the turn
signal lights by operating the turn signal switch.
• If the light does not come on, check for an open
circuit in the White/green and Gray wires.
• If the light comes on, check the connector termi ­
nals for loose or poor contact.
If the connector terminals are OK, replace the
turn signal relay.
21-21