Honda VT750C2 Shadow Spirit Service Manual page 395

HYDRAULIC BRAKE
Install the brake light switch, aligning its boss with
the groove of the master cylinder.
Install and tighten the screw to the specified torque.
TORQUE: 1.2 N·m (0.1 kgf·m, 0.9Ibf·ft)
Apply 0.1 g of silicone grease to the brake lever
pivot sliding surface.
Install the brake lever and pivot bolt, and tighten it
to the specified torque.
TORQUE: 1 N·m (0.1 kgf·m, 0.7 Ibf·ft)
Tighten the nut to the specified torque while hold ­
ing the pivot bolt.
TORQUE: 6 N·m (0.6 kgf·m, 4.4 Ibf·ft)
Install the holder
Install the master cylinder with the holder and two
with its 'UP'mark
bolts.
facing up.
Align the edge of the master cylinder with the
punch mark on the handlebar and tighten the upper
bolt first, then tighten the lower bolt to the specified
torque.
TORQUE: 12 N·m (1.2 kgf·m, 9 Ibf·ft)
Be sure
to
rest the
Connect the brake hose to the master cylinder with
hose joint against
the oil bolt and new sealing washers.
the stopper.
Tighten the oil bolt to the specified torque.
TORQUE: 34 N·m (3.5 kgf·m, 25 Ibf·ft)
Install the rearview mirror.
Connect the brake light switch connectors.
Fill and bleed the hydraulic system (page 17-5).
SCREW
PIVOT BOLT/NUT
MASTER CYLINDER
17-12