Honda VT750C2 Shadow Spirit Service Manual page 375

REAR WHEEL/BRAKE/SUSPENSION
Apply grease to the joint pin.
Install the middle brake rod, joint pin and new cot­
ter.
Apply grease to the dust seal lips.
Install the dust seals into the brake pedal.
..
~JOINTPIN
Apply grease to the brake pedal pivot sliding sur ­
face.
Install the brake pedal assembly to the bracket prop­
erly.
Install the washer and snap ring.
NOTE:
• Install the washers and snap rings with the
chamfered edges facing the thrust load side.
• Do not reuse worn snap ring which could easily
spin in the groove.
• Check that the snap ring is seated in the grooves.
Hook the brake pedal and rear brake light switch
return springs to the pedal.
Apply grease to the dust seal lips and middle rod
joint pivot sliding surface.
Install the dust seals and middle rod joint pivot.
Install the middle rod joint to the pivot and tighten
the bolt securely.
...- - ­
I""':::;,,,,;---,,,"""---~
16-20