8
ELECTRIC STARTER
OPERATION CHECK
Remove the starter relay switch (page 20-16).
Connect a fully charged 12 V battery to the relay
switch as shown.
There should be continuity between the cable termi
nals while the battery is connected, and no continu
ity when the battery is disconnected.
REMQVALIINSTALLATION
Remove the following:
-
Right side cover (page 3-3)
-
Fuseboxlturn signal relay (page 19-8)
Turn the ignition switch to OFF.
Disconnect the battery negative (-) cable
(page 18-6).
Disconnect the starter relay 4P connector.
Remove the socket bolts and cables.
Remove the starter relay switch.
Installation is in the reverse order of removal.
DIODE
INSPEctiON
Remove the right side cover (page 3-3).
Open the fuse box cover and remove the diode.
20-16