Honda VT750C2 Shadow Spirit Service Manual page 288

CRANKSHAFT/TRANSMISSION
Press a new bearing into the bearing holder with the
marked side facing up until it is fully seated and
make sure it rotates freely after installation.
TOOL:
Oil seal driver 07965-KE80200
If the output driven
Support the bearing inner race and press the output
gear requires
driven gear into the bearing holder using the special
replacement, the
tools.
driven and drive
gear must be
TOOLS:
replaced as a set.
Driver, 40 mm 1.0. 07746-0030100
Attachment, 30 mm 1.0. 07746-0030300
Coat a new O-ring with engine oil and install it into . ,
--:7M
O-RING
the bearing holder groove. __
Install the shim.
NOTE:
When the -bearing, gear, holder and/or case have
been replaced, use the 0.40 mm (0.016 in) shim for
. initial reference.
DRIVER
.,
BEARING
.,.
.
ATTACHMENT
.
II
SHIM
Holdthl;l output gear case in a vise with soft jaws.
Install the driven gear assembly into the gear case,
aligning with the bolt holes.
Apply engine oil to the threads and seating surface
of the bolts and tighten them.
TORQUE:·31 N·m (3.2kgf·m, 23 Ibf.ft)
13-41