Turn Signal Light - Honda CBR650F Service Manual

dummyhead dummyhead
LIGHTS/METERS/SWITCHES
Disconnect the headlight 3P (Black) connector [1].
Remove the dust cover [2].
Unhook the bulb retainer [3] and remove the headlight
bulb [4].
Installation is in the reverse order of removal.
• Align the bulb tabs with the grooves properly.
• Install the dust cover with its arrow mark [5] facing
up.
HEADLIGHT UNIT REMOVAL/
INSTALLATION
CBR650F/FA: Refer to page 2-7.
Remove the headlight stay assembly from the headlight
CB650F/FA:
cover assembly (page 2-7).
Disconnect the headlight 3P (Black) connector [1] and
position light 4P (Black) connector [2].
Remove the three bolts [3], collars [4] and headlight unit
[5] from the headlight stay [6].
Installation is in the reverse order of removal.
POSITION LIGHT
INSPECTION
Turn the ignition switch ON and engine stop switch " ".
Check the position light operation.
Check that LEDs in the headlight unit illuminate with the ignition switch ON.
If any LED does not turn on, replace the headlight unit.

TURN SIGNAL LIGHT

BULB REMOVAL/INSTALLATION
Remove the screw [1] and collar [2].
Remove the turn signal light lens [3] by releasing the
tab [4].
While pushing the bulb [5] in, turn it counterclockwise to
remove it.
Make sure the rubber seal [6] in the light housing is
installed in position and is in good condition, and
replace it with a new one if necessary.
Installation is in the reverse order of removal.
TORQUE:
Turn signal light lens screw:
1.5 N·m (0.2 kgf·m, 1.1 lbf·ft)
21-4
[3]
[6]
[5]
[3]/[4]
[6]
[3]
[2]
[1]
[4]
[4]
[5]
[2]
[1]
[1]
[2]
[5]