Oil Pressure Indicator - Honda VT750C2 Shadow Spirit Service Manual

LIGHTS/METERS/SWITCHES
REPLACEMEI\lT
Drain the coolant (page 7-7).
Disconnect the connector from the fan motor
switch.
Remove the fan motor switch from the radiator.
Install a new O-ring into the fan motor switch
groove.
Install and tighten the fan motor switch.
TORQUE: 18 N·m (1.8 kgf·m, 13 Ibf·ft)
Connect the connector to the fan motor switch.
Fill and bleed the cooling system (page 7-7).
OIL PRESSURE INDICATOR
INSPECTION
Indicator does not come on with the ignition switch
turned to ON
Check that the neutral and coolant temperature indi ­
cators function properly.
If they do not function properly, check the power
input line ofthe speedometer (page 21-9).
Remove the left crankcase rear cover (page 3-5).
Remove the rubber cap, and disconnect the EOP
switch wire by removing the terminal screw.
Ground the wire terminal.
Turn the ignition switch to ON and check the oil
pressure indicator.
• If the indicator comes on, replace the EOP
switch.
• If the indicator does not come on, check for an
open circuit in the Blue/red wire. If the wire is OK,
replace the speedometer (page 21-10).
Indicator stays on while the engine is running·
Remove the rubber cap, and disconnect the EOP
switch wire by removing the terminal screw.
Check for continuity between the wire terminal and
ground.
• If there is, check for a short circuit in the Blue/red
wire.
• If there is no continuity, check the oil pressure
(page 5-5).
If the oil pressure is normal, replace the EOP
switch.
After inspection, connect the EOP switch wire and
tighten the terminal screw.
TORQUE: 1.9 N·m (0.2 kgf·m, 1.4 Ibf·ft)
Install the rubber cap properly.
Install the left crankcase rear cover (page 3-5).
OIL PRESSURE INDICATOR
21-15