COOLING SYSTEM
INSTALLATION
Install the thermostat by aligning its flange with the
thermostat housing slot.
Install a new O-ring into the thermostat housing
groove.
Install the thermostat housing to the cover and
tighten the bolts to the specified torque.
TORQUE: 10 N·m (1.0 kgf·m, 7Ibf·ft)
Connect the ECT sensor switch connector.
Fill and bleed the cooling system (page 7-7).
Install the steering side covers (page 3-5).
THERMOSTAT HOUSING
REMOVAL/INSTALLATION
Drain the coolant from the system (page 7-71.
Remove the steering side covers (page 3-5).
Disconnect the ECT sensor switch connector.
Loosen the water hose band screws and disconnect
the w&terhoses.
Disconnect the siphon
hose~
Remove the bolt and thermostat housing assembly.
7-9