Mazda CX-7 2007 Workshop Manual page 1573

LIFTGATE LOCK STRIKER REMOVAL/INSTALLATION
1. Remove the trunk end trim. (See 09-17-24 TRUNK END TRIM REMOVAL/INSTALLATION.)
2. Remove the bolts, then remove the liftgate lock
striker.
3. Install in the reverse order of removal.
4. Adjust the liftgate. (See 09-11-6 LIFTGATE
ADJUSTMENT.)
End Of Sie
WM: IMMOBILIZER SYSTEM
COIL ANTENNA REMOVAL/INSTALLATION
Note
• Do not remove the coil antenna unless you are replacing it.
1. Disconnect the negative battery cable.
2. Disconnect the coil antenna connector.
3. Detach the steering lock tabs from the holes on
the coil antenna.
4. Install in the reverse order of removal.
End Of Sie
IMMOBILIZER SYSTEM COMPONENT REPLACEMENT/KEY ADDITION AND CLEARING[ADVANCED
KEYLESS SYSTEM]
Foreword
• When performing the following procedures, the immobilizer resetting procedure using the M-MDS must also
always be performed: "Keyless control module replacement", "PCM replacement", "Steering lock unit
replacement", "Keyless control module and PCM joint replacement", "Keyless control module, PCM, and
steering lock unit joint replacement", and "Key ID number clearing". The engine will not start unless all work is
performed using the M-MDS.
• A card key that can start the engine is necessary for the key programming. If there is no card key that can start
the engine, perform the key programming after the card key programming. (See 09-14-33 CARD KEY ID CODE
REGISTRATION[ADVANCED KEYLESS SYSTEM].)
• There are two ways to add supplemental key: Using the M-MDS or using two keys that can start the engine to
program.
• When replacing any of the immobilizer system component parts, adding/clearing keys, or performing other
functions, refer to the following table and perform the applicable procedure (No.1 to 5).
• Verify that the room fuse is equipped.
Ref. No. Condition
Since two or more keys that can
start the engine are necessary,
1
make a spare key. Or program an
additional key.
If there is only one key that can
start the engine, make a spare key.
2
If there is no key, program an
additional key.
SECURITY AND LOCKS
BOLT
18.6—25.5 N·m
{1.90—2.60 kgf·m,
13.8—18.8 ft·lbf}
COIL ANTENNA
Items necessary for
procedure (prepare
Cautionary notes
before starting
procedure)
• Programming key
• Programmed card
key
-
• Programming key
• M-MDS
LIFTGATE
LOCK STRIKER
TAB
HOLE
COIL ANTENNA
CONNECTOR
• The M-MDS is necessary for the additional key
programming if "Customer spare key
programming disable" is performed before the
procedure using the M-MDS. In this case,
perform No. 2.
id091400804100
acxuuw00002488
id091400804900
09-14
acxuuw00002489
id0914008050b1
09-14–11