Mazda CX-7 2007 Workshop Manual page 1642

Center
1. Remove the following parts:
(1) Front scuff plate inner (See 09-17-19 FRONT SCUFF PLATE REMOVAL/INSTALLATION.)
(2) Front side trim (See 09-17-18 FRONT SIDE TRIM REMOVAL/INSTALLATION.)
(3) Console panel (See 09-17-15 CONSOLE PANEL REMOVAL/INSTALLATION.)
(4) Console (See 09-17-13 CONSOLE REMOVAL/INSTALLATION.)
(5) Hood release lever (See 09-14-25 HOOD LATCH AND RELEASE LEVER REMOVAL/INSTALLATION.)
(6) Lower panel (See 09-17-9 LOWER PANEL REMOVAL/INSTALLATION.)
(7) Center panel (See 09-17-8 CENTER PANEL REMOVAL/INSTALLATION.)
2. Remove the screws.
3. Remove the ventilator grille.
4. Install in the reverse order of removal.
End Of Sie
SAIL GARNISH REMOVAL/INSTALLATION
1. Pull the sail garnish outward and detach clips A
and B.
2. Remove the sail garnish.
3. Install in the reverse order of removal.
End Of Sie
KNEE BOLSTER REMOVAL/INSTALLATION
1. Remove the following parts:
(1) Console panel (See 09-17-15 CONSOLE PANEL REMOVAL/INSTALLATION.)
(2) Console (See 09-17-13 CONSOLE REMOVAL/INSTALLATION.)
(3) Front scuff plate inner (driver's side) (See 09-17-19 FRONT SCUFF PLATE REMOVAL/INSTALLATION.)
(4) Front side trim (driver's side) (See 09-17-18 FRONT SIDE TRIM REMOVAL/INSTALLATION.)
(5) Hood release lever (See 09-14-25 HOOD LATCH AND RELEASE LEVER REMOVAL/INSTALLATION.)
(6) Lower panel (driver's side) (See 09-17-9 LOWER PANEL REMOVAL/INSTALLATION.)
2. Remove the bolts.
3. Remove the knee bolster.
4. Install in the reverse order of removal.
End Of Sie
WM: CONSOLE
09-17–12
INTERIOR TRIM
SCREW
SCREW
CLIP A
CLIP B
KNEE BOLSTER
VENTILATOR
GRILLE
acxuuw00000881
id091700805000
A
B
SAIL GARNISH
acxuuw00000918
id091700804000
BOLT
1.6—2.2 N·m
{16.4—22.4 kgf·cm,
14.2—19.4 in·lbf}
acxuuw00000794