Mazda CX-7 2007 Workshop Manual page 1408

SYMPTOM TROUBLESHOOTING [POWER WINDOW SYSTEMS (AUTO-OPEN/
STEP
4 REINSPECT DOOR GLASS CLOSING
SPEED
• Does the door glass hesitate periodically (5-6
times) while it is closing?
5 INSPECT GLASS RUN CHANNEL AND
DOOR GLASS SLIDING SURFACE
• Is there an object caught between the glass
run channel and the door glass, or is there
roughness on the sliding surface (rubber
surface)?
6 INSPECT TIGHTENING OF DOOR
GLASS TO CARRIER PLATE
• Is it normal?
7 INSPECT CONDITION OF GLASS RUN
CHANNEL AND DOOR GLASS
• Is it normal?
8 INSPECT DOOR GLASS CLOSING
SPEED
• Does the door glass hesitate at any location?
Affx tape to rear edge
End Of Sie
09-03A–12
CLOSE FUNCTION)]
INSPECTION
Yes Replace the power window motor, then go to Step 8 (See
09-12-7 POWER WINDOW MOTOR REMOVAL/
INSTALLATION.)
No Go to Step 8.
Yes Object is caught between glass run channel and
door glass:
• Remove the object.
Roughness on the sliding surface (rubber
surface):
• Replace the glass run channel.
After performing one of the above actions, reinspect.
If the malfunction is not corrected, go to Step 3.
No Go to the next step.
Yes Go to the next step.
No After tightening correctly, reinspect.
If the malfunction is not corrected, go to Step 3.
Yes Go to the next step.
No Assemble the glass run channel and door glass securely,
and reinspect.
If the malfunction is not corrected, go to Step 3.
Yes Repeat the inspection from Step 3.
No Troubleshooting completed.
If door glass slips rearward slightly
If door glass slips forward slightly
Speed change position
ACTION
acxuuw00000938