9. Remove the rear door glass guide and glass run
channel as a single unit.
10. Remove the hole cover.
11. Remove the bolt
12. Lift the rear door glass up and remove it in the
direction of the arrow.
13. Install in the reverse order of removal.
End Of Sie
WM: WINDOW REGULATOR
FRONT POWER WINDOW REGULATOR REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the following parts:
(1) Inner garnish (See 09-17-20 INNER GARNISH REMOVAL/INSTALLATION.)
(2) Front door trim (See 09-17-20 FRONT DOOR TRIM REMOVAL/INSTALLATION.)
(3) Front door speaker. (See 09-20-6 FRONT DOOR SPEAKER REMOVAL/INSTALLATION.)
(4) Front door glass (See 09-12-3 FRONT DOOR GLASS REMOVAL/INSTALLATION.)
(5) Power window motor (See 09-12-7 POWER WINDOW MOTOR REMOVAL/INSTALLATION.)
(6) Front beltline molding (See 09-16-9 FRONT BELTLINE MOLDING REMOVAL/INSTALLATION.)
3. Remove the nuts .
GLASS/WINDOWS/MIRRORS
REAR DOOR
GLASS GUIDE
GLASS RUN CHANNEL
BOLT
4.5—6.5 N·m {46—66 kgf·cm,
40—57 in·lbf}
HOLE COVER
NUT
6.7—9.8 N·m
{69—99 kgf·cm,
60—86 in·lbf}
acxuuw00001483
09-12
acxuuw00001484
id091200800200
acxuuw00001466
09-12–5