Mazda CX-7 2007 Workshop Manual page 1496

REAR BUMPER DISASSEMBLY/ASSEMBLY
1. Disassemble in the order indicated in the table.
1 Locator pin
2 Screw A
3 Rear reflector
(See 09-10-6 Reflector Removal Note)
4 Bumper guard
5 Screw B
6 Rear bumper fascia
2. Assemble in the reverse order of disassembly.
Reflector Removal Note
1. Remove the screw.
2. Pull off the reflector from the rear bumper in the
direction shown by the arrow.
End Of Sie
REAR BUMPER REINFORCEMENT REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the rear combination light. (See 09-18-5 FRONT COMBINATION LIGHT REMOVAL/INSTALLATION.)
3. Remove the rear bumper. (See 09-10-4 REAR BUMPER REMOVAL/INSTALLATION.)
4. Remove the fasteners, then remove the energy-
absorbing foam.
5. Remove the nuts, then remove the rear bumper
reinforcement.
6. Install in the reverse order of removal.
End Of Sie
WM: FRONT FENDER PANEL
09-10–6
BODY PANELS
3
TAB
PUSH
REAR BUMPER
REINFORCEMENT
4
1
2
2
TAB
PUSH
SCREW
REFLECTOR
NUT
37.3—52.0
{3.81—5.30, ENERGY-ABSORBING
27.6—38.3}
FOAM
N·m {kgf·m, ft·lbf}
id091000800800
5
4
6
acxuuw00001313
acxuuw00001314
id091000800900
37.3—52.0
{3.81—5.30,
27.6—38.3}
NUT
FASTENER
acxuuw00001315