Mazda CX-7 2007 Workshop Manual page 1608

2007 mazda cx-7

Hide thumbs Also See for CX-7 2007:

Table of Contents

Sunroof Motor Assembly Note

• If the guide or sunroof motor is removed, the sunroof motor initial position setting has to be performed.

After installing the sunroof unit, perform the initial position setting using the following procedure.

1. The initialization mode starts after approx. 13 s from when the tilt up switch has been pressed and held. The

glass stops after it has moved approx. 30 mm towards the closed position.

• Only the tilt up switch is available during the initialization mode.

• The initialization may finish at the first inching operation depending on the glass position when the motor

is installed.

• If the glass position is between the closed and semi-tilt positions when the motor is removed, the glass

moves in the tilt up direction (to the full tilt position stored in the motor). However, if the tilt up switch is

pressed and held, the initialization mode starts.

2. When the tilt up switch is pressed again, the glass continues to move approx. 30 mm and stops.

3. Repeat this procedure several times so that the glass moves to the fully closed, full tilt (normal operation

position), and full tilt (mechanical stopper position) positions.

4. After the glass is moved to the full tilt position (mechanical stopper position), it returns to the tilt down direction

slightly and the initialization is completed.

Rear Drip Assembly Note

• If the rear drip is removed, butyl seal must be applied when re-installing.

1. Apply a 6.0— 8.0 mm {0.24— 0.31 in} wide line

of butyl seal to the area shown in the figure.

Guide Disassembly Note

1. Place an alignment mark on the guide pin and

acxuuw00001196

acxuuw00001197

Show Quick Links

Chapters

Table of Contents