Mazda CX-7 2007 Workshop Manual page 1537

QUARTER WINDOW GLASS REMOVAL
1. Remove the following parts:
(1) Rear scuff plate inner (See 09-17-19 REAR SCUFF PLATE REMOVAL/INSTALLATION.)
(2) Rear seat (See 09-13-7 REAR SEAT REMOVAL/INSTALLATION.)
(3) Sub trunk box (See 09-17-25 SUB TRUNK BOX REMOVAL/INSTALLATION.)
(4) Trunk end trim (See 09-17-24 TRUNK END TRIM REMOVAL/INSTALLATION.)
(5) Trunk side trim (See 09-17-24 TRUNK SIDE TRIM REMOVAL/INSTALLATION.)
(6) C-pillar trim (See 09-17-17 C-PILLAR TRIM REMOVAL/INSTALLATION.)
(7) D-pillar trim (See 09-17-18 D-PILLAR TRIM REMOVAL/INSTALLATION.)
2. Set the headliner out of the way.
3. Apply protective tape along the edge of the body
and the quarter window glass.
Not Reusing Windshield
Note
• For the areas of the sealant that are difficult to cut, use the piano wire and follow the procedure under
"Reusing Windshield".
1. Cut out the sealant all around the glass from
inside the vehicle using a sealant remover.
Warning
• Using a razor with bare hands can cause
injury. Always wear gloves when using a
razor.
2. Remove the quarter window glass.
GLASS/WINDOWS/MIRRORS
BODY SIDE
PROTECTIVE TAPE
A
A
GLASS SIDE
id091200801700
SEC. A—A
acxuuw00001577
09-12
SEALANT
REMOVER
49 G050 1A0
acxuuw00001579
09-12–27