Mazda CX-7 2007 Workshop Manual page 1617

REAR DOOR GARNISH REMOVAL/INSTALLATION
1. Remove the sail garnish. (See 09-17-12 SAIL GARNISH REMOVAL/INSTALLATION.)
2. Remove the rear beltline molding. (See 09-16-9 REAR BELTLINE MOLDING REMOVAL/INSTALLATION.)
3. Remove the screws.
4. Pull the rear door garnish in the direction shown
by the arrow and remove clip A from the rear door
garnish.
5. Remove the rear door garnish.
6. Remove clips A from the body, then install it to the
rear door garnish.
7. Install in the reverse order of removal.
End Of Sie
REAR FINISHER REMOVAL/INSTALLATION
1. Remove the liftgate upper trim. (See 09-17-25 LIFTGATE UPPER TRIM REMOVAL/INSTALLATION)
2. Remove the liftgate side trim. (See 09-17-25 LIFTGATE SIDE TRIM REMOVAL/INSTALLATION)
3. Remove the liftgate lower trim (See 09-17-26 LIFTGATE LOWER TRIM REMOVAL/INSTALLATION.)
4. Remove the nuts at section C indicated in the
figure.
5. Pull the rear finisher outward, then disengage clip
A, B from the body.
6. Install in the reverse order of removal.
End Of Sie
EXTERIOR TRIM
CLIP A
B
CLIP A
SCREW
A
NUT
3.9—5.8 N·m
{39.8—59.1 kgf·cm,
34.6—51.3 in·lbf}
A
CLIP B
C
C
id091600804200
REAR DOOR
GARNISH
acxuuw00000903
id091600800200
09-16
C
acxuuw00000887
09-16–3