Mazda RX-8 Workshop Manual page 1947

connector terminals?
INSPECT SHIFT SOLENOID D CIRCUIT FOR SHORT TO
10
POWER SUPPLY
Turn the ignition switch to the LOCK position.
Disconnect the couple component connector.
Turn the ignition switch to the ON position
(engine off).
Measure the voltage at couple component
(wiring harness-side) terminal L.
Is there 0 V at the TCM wiring harness-side
connector terminals?
VERIFY TROUBLESHOOTING OF DTC P0983
11
COMPLETED
Make sure to reconnect all the disconnected
connectors.
Clear the DTC from the memory using the M-
MDS.
Drive the vehicle in D range and make sure
that gears shift smoothly from 1GR to 6GR.
Is same DTC present?
VERIFY AFTER REPAIR PROCEDURE
12
Perform the "After Repair Procedure".
(See AFTER REPAIR PROCEDURE
Are any DTCs present?
< Previous Next >
YesRepair or replace the wiring harness (TCM—couple component)
No Repair or replace the wiring harness (couple component—shift
YesReplace the TCM, then go to the next step.
No Go to the next step.
YesGo to the applicable DTC inspection.
[SJ6A-EL].)
No Troubleshooting completed.
© 2010 Mazda North American Operations, U.S.A.
for short to power supply, then go to the next step.
solenoid D) for short to power supply, then go to the next step.
(See TCM REMOVAL/INSTALLATION
(See DTC TABLE [SJ6A-EL].)
[SJ6A-EL].)
Back to Top