Mazda RX-8 Workshop Manual page 1989

6 INSPECT LINE PRESSURE
Start the engine.
Measure the line pressure.
(See
[SJ6A-EL].)
Are the line pressures within the
specifications?
VERIFY TROUBLESHOOTING OF DTC P0752
7
COMPLETED
Make sure to reconnect all
disconnected connectors.
Clear the DTC from the TCM
memory using the M-MDS.
Start the engine.
Warm up AT.
Drive the vehicle in D range and
make sure that the gears shift
smoothly from 1GR to 6GR.
Is the PENDING CODE same as
the DTC present?
VERIFY AFTER REPAIR PROCEDURE
8
Perform the "After Repair
Procedure".
(See
[SJ6A-EL].)
Are any DTCs present?
< Previous Next >
MECHANICAL SYSTEM TEST
AFTER REPAIR PROCEDURE
© 2010 Mazda North American Operations, U.S.A.
YesGo to the next step.
No All ranges: Replace the oil
pump or control valve body,
then go to the next step.
Any ranges: Replace the AT,
then go the next step.
(See AUTOMATIC
TRANSMISSION
REMOVAL/INSTALLATION
[SJ6A-EL].)
YesReplace the TCM, then go to the next step.
(See TCM REMOVAL/INSTALLATION [SJ6A-
EL].)
No Go to the next step.
YesGo to the applicable DTC inspection.
(See DTC TABLE
No DTC troubleshooting completed.
[SJ6A-EL].)
Back to Top