Mazda RX-8 Workshop Manual page 2037

Inspect for poor connection at shift solenoid G terminals A and
B (such as damaged/pulled-out pins, corrosion).
Are terminals normal?
INSPECT SHIFT SOLENOID G
11
Inspect the shift solenoid G.
(See SOLENOID VALVE INSPECTION
Is the shift solenoid G normal?
INSPECT SHIFT SOLENOID G CIRCUIT FOR OPEN CIRCUIT
12
Inspect for continuity between couple component terminals
and shift solenoid G terminals (wiring harness-side).
Is there continuity?
VERIFY TROUBLESHOOTING OF DTC P2720 COMPLETED
13
Make sure to reconnect all the disconnected connectors.
Clear the DTC from the memory using the M-MDS.
Drive the vehicle in D range and make sure that gears shift
smoothly from 1GR to 6GR.
Is same DTC present?
VERIFY AFTER REPAIR PROCEDURE
14
Perform the "After Repair Procedure".
(See AFTER REPAIR PROCEDURE
Are any DTCs present?
< Previous Next >
[SJ6A-EL].)
Terminal D and terminal B
Terminal C and terminal A
[SJ6A-EL].)
© 2010 Mazda North American Operations, U.S.A.
No Repair or replace the connector and/or
terminal, then go to Step 13.
YesGo to the next step.
No Replace the control valve body, then go to
Step 13.
(See CONTROL VALVE BODY REMOVAL [SJ6A-
EL].)
(See CONTROL VALVE BODY INSTALLATION
[SJ6A-EL].)
YesGo to the next step.
No Repair or replace the couple component, then
go to the next step.
YesReplace the TCM, then go to the next step.
(See TCM REMOVAL/INSTALLATION [SJ6A-
EL].)
No Go to the next step.
YesGo to the applicable DTC inspection.
(See DTC TABLE [SJ6A-EL].)
No Troubleshooting completed.
Back to Top