Display Transceiver Diagnosis - H3C S5120-EI Series Command Reference Manual

TX power high
TX power low
Temp high
Temp low
Transceiver info I/O error
Transceiver info checksum error
Transceiver type and port configuration
mismatch
Transceiver type not supported by port
hardware
Examples
# Display the alarm information of the pluggable transceiver plugged in interface GigabitEthernet
1/0/1. (The output of this command varies with devices.)
<Sysname> display transceiver alarm interface gigabitethernet1/0/1
GigabitEthernet1/0/1 transceiver current alarm information:
RX loss of signal
RX power low
Table 26 Output description
Field
transceiver current alarm information
RX loss of signal
RX power low

display transceiver diagnosis

Syntax
display transceiver diagnosis { interface [ interface-type interface-number ] } [ | { begin | exclude |
include } regular-expression ]
View
Any view
Default level
2: System level
Parameters
interface [ interface-type interface-number ]: Displays the currently measured value of digital diagnosis
parameters of the H3C customized anti-spoofing pluggable optical transceiver plugged in the specified
interface. interface-type interface-number represents interface type and interface number. If it is not
specified, the command displays the currently measured value of digital diagnosis parameters of H3C
customized anti-spoofing pluggable optical transceivers in all the interfaces.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see the Fundamentals Configuration Guide.
TX power is high.
TX power is low.
Temperature is high.
Temperature is low.
Transceiver information read and write error
Transceiver information checksum error
Transceiver type does not match port configuration.
Transceiver type is not supported on the port.
Description
Current alarm information of the transceiver
Incoming (RX) signal is lost.
Incoming (RX) power level is low.
147