Extension Function 2 (Crosshair Cursor Display) - Sharp IV-S30 User Manual

(2) Extension function 2 (crosshair cursor display)

On the MAIN OPS MENU, move the cursor to "OPS-CND" item, and press the SET key.
[TYPE RUN COND]
8THROUGH DISPLAY NO YES
9EXTENSION FUNC.1 NO DISPLAY+CURSOR (1 2)(000,000) MANL-MEAS
0EXTENSION FUNC.2 NO DISPLAY+CURSOR (1 2)(000,000)
OPS-MENU SAVE LOCK
EXTENSION FUNC.2
NO
DISPLAY
+CURSOR(1,2)
Ë Ë Ë Ë Ë Operatiing procedure
1. On the [TYPE RUN COND] menu, move the cursor to "EXTENSION FUNC.2" with the up and
down keys, and press the SET key.
2. Move the cursor to "DISPLAY+CURSOR(1 2)" and press the SET key.
3. Move the crosshair cursor using the up/down and left/right keys (it moves one pixel at a time).
4. After the position is determined, press the SET key.
Using "0EXTENSION FUNC.1" simultaneously, you can have two crosshair cursors while the
monitor outputs CAM1&2(HORZ VERT).
[Display example]
(TYPE00)AREA1
OK
MEAS XXXXms 2000-08-01 10:30
MEASURE 0 CAM1 POSI-DEVIATION
X0~7
CHG-MEA CHG-REG CHG-RST
OPS-CND MEA-CND SYS-CND
Select when you will not use the extension function
The crosshair cursor can be displayed on any position.
- "1" equals a 16-pixel line. "2" equals a full line.
- The initial coordinates of the crosshair cursor center are
(225, 240)
Y0~7 READY
CHG-C1 CHG-C2
CHG-TYPE NG-IMG-DSP NEXT-NG
Display two cursors
2-13
Setting the Operating and System Conditions
Description
CHG-EVAL CUSTOM-MNU
MANL-MEAS
8 0 display when
the MONITOR
OUTPUT is set to
"CAM1/CAM2/NG-IMG"
Camera 1
measurement
image
Camera 2
measurement
image
2