Measurement Start Input = Ccd Trigger, Start Sampling = Auto, Object Type Change = General Purpose Serial, Result Output = General Purpose Serial/Parallel - Sharp IV-S30 User Manual

(10) Measurement start input = CCD trigger, start sampling = auto, object type change = general
purpose serial, result output = general purpose serial/parallel
The general purpose serial command (code 55
Setting order
[SYSTEM COND]
1I/O CONDITIONS (TO NEXT SUB-MENU)
2COMM.SET
(TO NEXT SUB-MENU)
[I/O CONDITIONS]
1MEAS INP I/F
PARALLEL+SERIAL CCD-TRIG
2START CCD SAMPLE AUTO(EDGE LEVL) PARALLEL SERIAL+USB
3OUTPUT OBJ TYPE PARALLEL SERIAL+USB
Setting "17-3 CCD
trigger"
) is used to change the object type.
(H)
Configuration example
Camera 1 (image capturing + CCD trigger)
Camera 2 (image capturing)
Personal computer
Remote key pad
Select one of
the following.
Measurement is started when the CCD trigger level is ON.
Measurement is started when a CCD trigger signal is received.
CCD trigger
Measurement
17-15
Setting the Input/Output Conditions
Data
Controller
Power supply (24 VDC)
Black White
Work
Edge
Level
Monitor
17