Sharp IV-S30 User Manual page 38

*3 Set the measurement
start input to any choice
other than "parallel" or
set the 'READY' ON
signal to "end
measurement."
- When the stop NG measurement option is set to "YES" (page 3-37), the controller stops measuring
when an error occurs.
From the previous page
Determining the measuring time (timer stop)
Parallel output (Y0 to Y15) OFF
External interface enabled (communications)
No
Serial output
General purpose serial output
External interface enabled (key, parallel)
No
Yes
READY ON
Waiting for a measurement start input signal or a key input
1-27
Setting and Operating Outline
Computer link
General purpose
Computer link output
*3
1