Sharp IV-S30 User Manual page 163

Ë Ë Ë Ë Ë Setting procedure
- The number of styles may be set as follows, depending on the selections made in items 2 and 3.
2 OBJECT TYPE
COORD [X Y]
DEVIAT [x y]
MATCH [M]
ANGL [B]
NUM-CAL [NC]
CNST [C]
The numbers from 0 to 7 in front of the characters are registration numbers.
Specify the output for the
results of the calculations
Select the data to be calculated
Enter the number of styles
(Select an arithmetic function)
Set the judgment output conditions
Carry out a calculation
Enter the upper and lower limits
Not done
All recording is finished
Previous menu
Ë Ë Ë Ë Ë Output error
An error will be output if there are too many digits as well as if there is an attempt to divide by zero.
Ë Ë Ë Ë Ë Order of calculation
The calculation results are produced in order, from N00 to N15.
Ë Ë Ë Ë Ë Parallel output based on the output conditions
It is possible to use the parallel output for the evaluation results from the calculations by selecting
the PC function in the output conditions (the final output conditions are taken from the output
conditions set for each measurement program)
Model 0
0X0 to 7X0 / 0Y0 to 7Y0
0x0 to 7x0 / 0y0 to 7y0
0M0 to 7M0
0B to 7B
ABS / SQRT / TAN / ATAN (00 to 14)
MAX/MIN (00 to 14)
-9999999.99 to +9999999.99
Setting the headings on the [NUMERIC CALC]
(numerical calculation) menu.
1 CALC RESULT
2 TYPE
3 FORMULA
(4
FUNCTION)
6 OUTPUT
7 RUN A TEST
5 UPR & LOW LIMIT
Done
"RETURN"
15-3
Numerical Calculations
Model 1
0X1 to 7X1 / 0Y1 to 7Y1
0x1 to 7x1 / 0y1 to 7y1
0M1 to 7M1
Note: Make sure that a test
is run using the
[EVALUATION
COND] (evaluation
condition) menu
before making any
calculations.
Corresponds to
page 15-4
These are the
same as for the
other
measurement
programs.
15