Table of Contents
Advertisement
[1] Monitor output
When two cameras have been connected to IV-S30, you can switch back and forth between the image
from the cameras on one monitor. Also, the monitor screen can be divided into two parts to display the
two images simultaneously.
- Purpose of the setting
To set the conditions in which an image captured during measurement will be displayed on the run
menu.
- Output monitor switching
The monitor can be switched by two methods, i.e. key pressing or parallel input.
(1) Monitor output switching by key presses
To specify a monitor, select the "1MONITOR OUTPUT" option on the [TYPE RUN COND] menu.
Before making this setting, select the cameras whose images will be shown (Camera 1 & 2, Camera
1 & NG image). - See page 3-3.
On the MAIN OPS menu screen, move the cursor to [TYPE RUN COND], and press the SET key.
When CAM1&2 is selected for use.
[TYPE RUN COND]
1MONITOR OUTPUT CAM1 CAM2 CAM1&2(HORIZ VERT)
2CAPTURE IMG
1
MONITOR OUTPUT
CAM1
CAM2
1
CAM1&2*
CAM1&2(HORIZ VERT)*
CAM1&2(HORIZ VERT)*
When CAM1&NG-IMG is selected for use
[TYPE RUN COND]
1MONITOR OUTPUT CAM1 NG-IMG CAM1&NG-IMG(HORIZ VERT)
2CAPTURE IMG
1
MONITOR OUTPUT
CAM1
NG-IMS
CAM1&NG-IMG*
CAM1&NG-IMG*
(HORIZ VERT)
CAM1&NG-IMG*
(HORIZ VERT)
1
*
: When IV-S31M/S32M is used *
Operating procedure
1. Move the cursor to "1MONITOR OUTPUT" using the up and down keys and press the SET key.
2. When "CAM1&2" is selected for use, move the cursor to "CAM1," "CAM2" or "CAM1&2(HORIZ
VERT )" using the left and right keys and press the SET key. When "CAM1&NG-IMG" is selected
for use, move the cursor to "CAM1," "NG-IMG" or "CAM1&NG-IMG(HORIZ VERT)" using the left
and right keys and press the SET key.
Setting the Operating and System Conditions
PARTIAL-IMG
WHOLE-IMG
Display the camera 1 image on the whole screen.
Display the camera 2 image on the whole screen.
Display the camera 1 image on upper half, and the camera 2 image
on lower half.
2
Display the camera 1 image on left half, and the camera 2 image on
2
right half.
PARTIAL-IMG
WHOLE-IMG
2
Display the camera 1 image on the whole screen.
Display the image on the whole screen
1
Display the camera 1 image on upper half, and the NG image on
2
lower half.
2
Display the camera 1 image on left halt, and the NG image on
right half.
2
: When IV-S33M is used
2-3
F.IMG C1 L
Indicat camera 1 is selected.
When CAM2 is selected on
NO
1MONITOR OUTPUT, "C2" is
2
displayed. When CAM1&2 is
selected "C1/C2" will be displayed.
Description
F.IMG NG L
Indicates NG image is
selected.
NO
When CAM1 is selected on
1MONITOR OUTPUT,
When IV-S33M is
"C1" is displayed. When
selected, this will
CAM1&NG-IMG is selected,
be displayed.
"C1/NG" will be displayed.
Description
.
2
Advertisement
Table of Contents
