Sharp IV-S30 User Manual page 219

Setting the Input/Output Conditions
Ë Setting procedure (when the numerical calculation conditions for measuring positional deviations is
selected)
1. On the [NUMERIC CALC COND] menu, move the cursor to the "LOCK" item, and press the SET key.
[NUMERIC CALC]
1CALC RESULT N00(0~15) NO YES
2TYPE
3FORMULA
4FUNCTION
5UPR&LOW LIMIT +0000000.0000~+0000000.0000
6OUTPUT
7RUN A TEST
1
OPS-MENU RETURN LOCK
[NUMERIC CALC]
1CALC RESULT MENU YES
2TYPE
3FORMULA
4FUNCTION
5UPR&LOW LIMIT MENU YES
6OUTPUT
7RUN A TEST
2
OPS-MENU SAVE RETURN
2. Move the cursor to the "6OUTPUT" item using the up and down keys, and press the SET key.
3. Move the cursor to "NO" on the "SERIAL OUTPUT" column and select it to "YES" or "NO" using the up and
down keys. Then, press the SET key.
17
COORD[X Y] DEVIAT[x y] MATCH[M]
ANGL[B] NUM-CAL[NC] CNST[C]
REG0(0~7) MDL0(0~1) N00(0~15)
CNST0000.0 + - / DEL END
*
SUM AVG REG0~0(0~7)
NO Y0(0~7) C000(0~107)
(SET KEY)
[MENU] [SERIALOUTPUT]
MENU YES
MENU YES
MENU YES
MENU YES NO
MENU YES
3
17-24