Sharp IV-S30 User Manual page 143

Existence Inspection by Point Measurement
Continued from the previous page
Æ When MODE has been set to "BINARY"
[EVALUATION COND]
1PAGE CHNG
2P000
3P001
4P002
5P003
6P004
7P005
8P006
9P007
0TEST
OPS-MENU RETURN LOCK
Æ When MODE has been set to AVG-GRAYS
[EVALUATION COND]
PAGE CHNG
CONDITION SET REST(+
P000
P001
P002
P003
P004
P005
P006
P007
TEST
OPS-MENU RETURN LOCK
11
- PAGE CHNG: The items appearing at points 3 to 0 can be scrolled up and down by the up and
- P***:
- TEST: Press the SET key, and a test will be executed using the specified evaluation conditions,
When you want to select a numeric calculation
- Select "RETURN" to return to the [MEAS COND] menu, and then select
"NUM-CALC" and press the SET key.
When you want to select a PC function
- Select "RETURN" to return to the [MEAS COND] menu, and then select
"OUT-COND" and press the SET key.
Return to the [MEAS COND] menu.
To the next page
- page 3-16
[TEST RESULT]
WHITE OK
WHITE OK
WHITE OK
WHITE OK
WHITE OK
EXEC (WITH-POSI.ADJ WITHOUT-POSI.ADJ)
- page 3-16
[TEST RESULT]
200~210 200
200~210 200
200~210 200
200~210 200
200~210 200
EXEC(WITH-POSI.ADJ WITHOUT-POSI.ADJ)
down keys, 8 items at a time. Press the SET key, and a test will be executed using
the specified evaluation conditions, and a test results will be displayed.
Set the evaluation conditions (WHITE/BLACK) for the point numbers 0 to 255 using
the up and down keys. The points of the selected numbers will blink. WHITE or
BLACK is not displayed for unregistered point numbers.
and the test results will be displayed.
- See "Chapter 15: Numerical Calculations"
- See "Chapter 16: PC Function"
Acceptance (OK/NG) criteria
WHITE: Acceptable when a majority of the inspected
pixels are white.
BLACK: Acceptable when a majority of the inspected
pixels are black.
Ex.: When the point to be inspected is 8 X 8 (64 pixels)
[OUTPUT]
and WHITE is specified, if 33 white pixels are
NO
detected, the point is accepted.
NO
You can set the output destinations using the up
NO
and down keys. (NO, Y0 to Y7, C000 to C127)
NO
NO
Not displayed for unregistered point numbers.
Average light level for each point
[OUTPUT]
OK NO
You can set the output destinations using the UP
OK NO
and DOWN keys. (NO, Y0 to Y7, C000 to C127)
OK NO
OK NO
OK NO
Not displayed for unregistered point numbers.
11-4