Table of Contents
Advertisement
[NTP] ntp is disabled
Server
Key Prefer
=============== ===== ======
Key # Key
======= ====================================
Time zone offset not set
2.7.9 Reset to Factory Defaults
Supermicro switches can be reset to the factory defaults using a CLI command.
Follow the steps below to reset to the factory defaults.
Step Command
Step 1
configure terminal
Step 2
reset-to-factory-defaults
Resetting to factory defaults will remove all stored configurations, files on the flash memory,
user accounts and the management IP address.
After resetting to factory defaults, the switch can be managed using the default
management IP address 192.168.100.102 with the default administrator user name ADMIN
and password ADMIN.
The example below shows the command to reset to the factory defaults.
SMIS(config)# reset-to-factory-defaults
This command will reset settings to the factory defaults.
After resetting to factory defaults, the switch will be reloaded immediately.
Do you really want to execute this command and reload the switch? [y/n]
2.8 Zero Touch Provisioning
Zero Touch Provisioning (ZTP) helps to auto provision Supermicro switches without manual intervention.
ZTP also helps to upgrade the switch firmware automatically.
SSE-G3548S/R switches come with the default management IP address set to DHCP mode. When switches
boot up, the management IP address is received from the DHCP server. The DHCP server can also be
configured to supply the switch configurations and firmware image when assigning IP addresses to
Supermicro switches.
2.8.1 ZTP Config Restore
This section explains details on using ZTP to automatically configure Supermicro switches.
2.8.1.1 DHCP Server Configuration
Switches expect the following information from the DHCP server to restore configurations supplied along
with DHCP IP.
Supermicro SSE-F3548S/SSE-F3548SR Configuration User's Guide
Description
Enters the configuration mode
Configure Factory Defaults.
69
Hide quick links:
Advertisement
Table of Contents
