Creating A New Definition By Copying An Existing Definition - Brocade Communications Systems Brocade 8/12c User Manual

30
Event custom reports
5. Choose between relative time (the default) and absolute time.
6. Click OK to save the definition, Run to launch the report.

Creating a new definition by copying an existing definition

Perform the following steps to copy an existing definition.
1. Select the definition you want to copy from the Report Definitions tab of the Event Custom
2. Click Duplicate.
3. Click the Identification tab to enter a new name and description for the new definition.
4. Make changes to the report as required.
5. Perform one of the following tasks when you are finished modifying the definition:
The new definition is added to the Report Definitions tab of the Event Custom Reports dialog box.
898
•
Click Relative Time if you want to filter traffic based on when the report is generated, and
then select a relative time from the Range list. Relative time is calculated based on the
date and time the report is generated.
•
Click Absolute Time if you want to filter traffic sent at a specific date and time.
a. Select the specific start date from the Start Date list.
b. Select the specific hour time from the Start Time list, and select AM or PM.
c. Select the specific end date from the End Date list.
d. Select the specific hour for the end time from the End Time list, and select AM or PM.
Reports dialog box.
The name of the definition is the name of the selected definition with the word "copy"
appended. For example, SelectedPortName becomes SelectedPortName copy.
•
Click OK to save the report.
•
Click Cancel to discard your changes and exit from the Report Definitions tab of the Event
Custom Reports dialog box.
•
Click Reset to discard your changes without exiting from the Report Definitions tab of the
Event Custom Reports dialog box.
•
Click Run to launch the report.
Brocade Network Advisor SAN User Manual
53-1002167-01