Creating A New Member In A Zone By Wwn - Brocade Communications Systems Brocade BladeSystem 4/24 User Manual

20
8. For offline zone databases only, complete the following steps to save the zone configuration
9. Click OK or Apply to save your changes.

Creating a new member in a zone by WWN

Use this procedure to add a member to a zone when the member is not listed in the Potential
Members list of the Zone DB tab.
For instructions to add a member to a zone when the member is listed in the Potential Members
list, refer to the procedure
1. Select Configure > Zoning > Fabric.
2. Click the Zone DB tab if that tab is not automatically displayed.
3. Select an FC fabric from the Zoning Scope list.
4. Select one or more zones to which you want to add members in the Zones list. (Press SHIFT or
5. Click New Member.
6. Select World Wide Name from the Member Type list.
7.
574
A message may display informing you that one or some of the selected potential members
cannot be zoned. Click OK to close the message box. Reconsider your selections and make
corrections as appropriate.
into the switch from the offline zone database:
a. Select Save to Switch from the Zone DB Operation list.
b. Click Yes on the confirmation message.
The selected zone database is saved to the fabric without enabling a specific zone
configuration.
A message displays informing you that any zones or zone configurations you have changed will
be saved in the zone database, and warning you to make sure no other user is making
changes to the same areas.
"Adding members to a zone"
The Zoning dialog box displays.
This identifies the target entity for all subsequent zoning actions and displays the zoning
database for the selected entity.
CTRL and click each zone name to select more than one zone.)
The Add Zone Member dialog box displays.
Add the new member by port name by completing the following steps.
a. Select the Existing End Device Node/Port Name option.
b. Select a port name from the list.
OR
Add the new member by port WWN by completing the following steps.
a. Select the End Device Node/Port WWN option.
b. Enter a port WWN in the End Device Node/Port WWN field.
on page 573.
DCFM Professional Plus User Manual
53-1001774-01