Privilege Level (Line Mode) - Dell Force10 S4810P Reference Manual

level
reset
command
Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
Usage Use the enable password command to define a password for the level to which you are
Information
assigning privilege or access.

privilege level (LINE mode)

Change the access level for users on the terminal lines.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax privilege level level
To delete access to a terminal line, use the no privilege level level command.
Parameters
level
Defaults level = 15
Command Modes LINE
Command History
Version 8.3.11.1
1410
•
•
•
level
Enter the keyword level followed by a number for the access level.
The range is 0 to 15.
Level 1 is EXEC mode and Level 15 allows access to all CLI modes and
commands.
Enter the keyword reset to return the security level to the default
setting.
Enter the command's keywords to assign the command to a certain
access level. You can enter one or all of the keywords.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
level
Enter the keyword level followed by a number for the access level.
The range is 0 to 15.
Level 1 is EXEC mode and Level 15 allows access to all CLI modes.
Introduced on the Z9000.
line for LINE mode
route-map for ROUTE-MAP mode
router for ROUTER OSPF, ROUTER RIP, ROUTER ISIS and
ROUTER BGP modes