Dot1X Authentication (Interface); Dot1X Auth-Fail-Vlan - Dell Force10 S4810P Reference Manual

Related

dot1x authentication (Interface)

Commands
dot1x authentication (Interface)
Enable dot1x on an interface; dot1x must be enabled both globally and at the interface level.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax dot1x authentication
To disable dot1x on an interface, use the no dot1x authentication command.
Defaults Disabled.
Command Modes INTERFACE
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.4.1.0
Related dot1x authentication (Configuration)
Commands

dot1x auth-fail-vlan

Configure an authentication failure VLAN for users and devices that fail 802.1X authentication.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax dot1x auth-fail-vlan vlan-id [max-attempts number]
To delete the authentication failure VLAN, use the no dot1x auth-fail-vlan vlan-
id [max-attempts number] command.
Parameters
vlan-id
max-attempts
number
Defaults 3 attempts
Command Modes CONFIGURATION (conf-if-interface-slot/port)
Command History
Version 8.3.7.0
Version 7.6.1.0
Usage
If the host responds to 802.1X with an incorrect login/password, the login fails. The switch
Information
attempts to authenticate again until the maximum attempts configured is reached. If the
1434
– enables dot1x on an interface.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the C-Series and S-Series.
Introduced on the E-Series.
– enables dot1x globally.
Enter the VLAN Identifier. The range is 1 to 4094.
(OPTIONAL) Enter the keywords max-attempts followed number
of attempts desired before authentication fails. The range is 1 to 5.
The default is 3.
Introduced on the S4810.
Introduced on the C-Series, S-Series, and E-Series.