Sflow Sample-Rate (Interface) - Dell Force10 S4810P Reference Manual

Defaults 32768 packets
Command Modes CONFIGURATION
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 8.2.1.0
Version 8.1.1.0
Version 7.7.1.0
Version 7.6.1.0
Version 7.4.1.0
Usage Sample-rate is the average number of packets skipped before the sample is taken. This
Information command changes the global default sampling rate. You can configure an interface to use a
different sampling rate than the global sampling rate. If the value entered is not a correct
power of 2, the command generates an error message with the previous and next power of 2
value. Select one of these two packet numbers and re-enter the command.
Related

sflow sample-rate (Interface)

Commands
sflow sample-rate (Interface)
Change the Interface default sampling rate.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax sflow sample-rate value
To return to the default sampling rate, use the no sflow sample-rate command.
Parameters
value
Defaults The Global default sampling.
Command Modes CONFIGURATION
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 8.2.1.0
Introduced on the Z9000.
Introduced on the S4810.
Introduced on S-Series Stacking.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
– changes the Interface sampling rate.
Enter the sampling rate value. For the C-Series and S-Series, the
range is 256 to 8388608 packets. For the E-Series TeraScale and
ExaScale, the range is 2 to 8388608. Enter values in powers of 2 only;
for example, 4096, 8192, 16384, etc. The default is the Global default
sampling.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on S-Series Stacking.
1475