T1600 Core Router Hardware Guide
Installing the T1600 Craft Interface
212
Repeat Step 3 for the other side of the craft interface.
4.
Grasp the craft interface by the top and bottom edges and carefully pull it straight
5.
out of the chassis.
Figure 116: Removing the Craft Interface
To install the craft interface (see Figure 117 on page 213):
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis. For more information about ESD,
see "T1600 Preventing Electrostatic Discharge Damage" on page 312.
Grasping the craft interface by the top and bottom edges, press it into place.
2.
Tighten the screws at the corners of the craft interface.
3.
NOTE: When you install the craft interface in an operating router, allow
several minutes for the LEDs on the craft interface to reflect the current
state of the router.
After you install the replacement craft interface, immediately reinstall the upper front
fan tray.
Copyright © 2010, Juniper Networks, Inc.